Sdc S6100 SERIES REVERSIBLE PANIC/FIRE EXIT Bedienungsanleitung PDF herunterladen (Seite 17)

C. MOUNT LATCH ASSEMBLIES

1. Attach latch mounting brackets to top and bottom latch assemblies

2. Insert top latch assembly into top of the door and fasten to the mounting plates

with the screws provided (figure 3-1).

3. Insert bottom latch assembly into bottom of the door and fasten to the mounting plates

with the screws provided (figure 3-2).

P:\INSTALLATION INST\Mechanical Hardware\INST-S6800.vsd Rev - 12/10 Page 5

Latch mounting bracket

Top latch assembly

Mounting

plate

Figure 3-1

Mounting

plate

Bottom latch

assembly

Latch mounting

bracket

Figure 3-2

D. ADJUST VERTICAL RODS

1. Place the rod length locator through the cut-outs on the inside face of the door. Hook a shaft

connector with the small stud on the locator. When the shaft connector is raised to as level as

possible, the holes C or D in the locator should align with the cut-outs A or B (figure 4-1).

2. If the C or D holes in the locator do not align with their respective cut-out, then the vertical rod

length is incorrect and must be adjusted.

Top latch

assembly

Bottom latch

assembly

Rod Length

Locator

Stud for

hooking

Cut-Out A

Cut-Out B

Hole C

Hole D

Figure 4-1

Top shaft

of Device

Bottom shaft

of Device

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23

Keine Kommentare

Sdc S6100 SERIES REVERSIBLE PANIC/FIRE EXIT Bedienungsanleitung Seite 17